Search FAQ / I am unable to turn stompboxes on/off via the iRig Stomp I/O, how do I get this working?

I am unable to turn stompboxes on/off via the iRig Stomp I/O, how do I get this working?

Make sure to first check that you are in Stomp Mode. This mode is designed to engage the AmpliTube stompboxes on/off. This mode is indicated with the Stomp Mode LED on your iRig Stomp I/O unit.

On the iRig Stomp I/O, press and hold Pedals 3 + 4 simultaneously to enter or exit Stomp Mode. Once done, an LED next to the unit's GAIN knob will light up red to indicate you are in Stomp Mode.

When you are outside of Stomp Mode, and you are not using the Looper, you will be using Preset mode. This mode is for switching between the different presets in AmpliTube.

Remember, when you are in Looper Mode, you must back out of Looper Mode first by pressing and holding switches 1 + 2, to then access Stomp Mode by pressing and holding Pedals 3 + 4.

See your user manual for a guide on using these different modes. This can be found at anytime in My Products after product registration. The different iRig Stomp I/O Modes are covered in Chapter 2 starting on page 9.

If this FAQ did not help get you started, please reach out to our support team here.

 
FAQ ID: 1150

 

SPECIAL OFFERS8 THIS MONTH
x

We use cookies and other tracking technologies to improve your browsing experience on our site, show personalized content and targeted ads, analyze site traffic, and understand where our audience is coming from. To find out more or to opt-out, please read our Cookie Policy. To learn more, please read our Privacy Policy.

Click below to consent to our use of cookies and other tracking technologies, make granular choices or deny your consent.

 


Loading...